|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Superb rendition. Drawings (schematics) complete and unabridged. I do a great deal of vintage audio restoration. Documentation is essential for successful repairs. I have found sources over the years that offer good documentation, but rarely all that is necessary. Owner's Manuals has filled that void with complete and legible documentation. They have narrowed my "favorites" to a more manageable collection. This Denon manual in particular contained the latest revisions level, and offered alterations favorable to updating the item. The Illustrated Parts Breakdown (IPB) was well enough detailed to simplify part symbols and physical locations. You will not be disappointed!
 ;
Clear and concise. Saved me a lot of time and money.
 ;
Superb manual. Exactly what I ordered and made available in a very timely manner.
 ;
very fast detailed and accurate hope to do business again
 ;
This was precisely what I was looking for. Complete and good quality!
Power Amplifier APPLICATIONS � Px600.2
The JBL Px600.2 amplifier can be set up for stereo or bridged-mono operation, as shown in Figures 4 and 5. NOTE: For simplicity, Figures 4 and 5 do not show power, remote and input connections.
PX600.2
Figure 4. The JBL Px600.2 amplifier is set to stereo mode to drive a pair of full-range speakers.
GND
REM
BATT
BRIDGED STEREO R L
NEON
NEON
Px600.2
POWER
FUSES
SPEAKER OUTPUTS
Px600.2
Set MODE to FLAT; INPUT MODE to ST
(on input panel) X-OVER
FREQ
(rear panel)
32Hz 320Hz FLAT HP LP MODE ST INPUT MODE MO
12dB 24dB SLOPE
R Speaker
L Speaker
FREQ and SLOPE have no effect
Figure 5. The JBL Px600.2 amplifier is set to bridged (mono) mode to drive a single subwoofer. Use this mode only when the nominal impedance of the subwoofer is 4 ohms or greater.
NEON
GND
REM
BATT
BRIDGED STEREO R L
NEON
Px600.2
POWER
FUSES
SPEAKER OUTPUTS
Px600.2
Set MODE to LP; INPUT MODE to MO
(on input panel) X-OVER
FREQ
(rear panel)
32Hz 320Hz FLAT HP LP MODE ST INPUT MODE MO
12dB 24dB SLOPE
Subwoofer (4 ohms or greater)
See �Setting the Crossover(s)� on page 6 to set FREQ and SLOPE For Stereo or Mono signals, use both L/R inputs
4
|
|
 |
> |
|